Document Type


Date of Degree

Fall 2014

Degree Name

MS (Master of Science)

Degree In

Civil and Environmental Engineering

First Advisor

Lee, Hosin "David"

First Committee Member

Nixon, Wilfrid

Second Committee Member

Hanley, Paul


Currently in Iowa, the amount of RAP materials allowed for the surface layer is limited to 15% by weight. The objective of this project was to develop quality standards for inclusion of RAP content higher than 15% in asphalt mixtures. To meet Superpave mix design requirements, it was necessary to fractionate the RAP materials. Based on the extensive sieve-by-sieve analysis of RAP materials, the optimum sieve size to fractionate RAP materials was identified. To determine if the higher percentage of RAP materials than 15% can be used in Iowa's state highway, three test sections with 30.0%, 35.5% and 39.2% of RAP materials were constructed on Highway 6 in Iowa City. The construction of the field test sections was monitored and the cores were obtained to measure field densities of test sections. Field mixtures collected from test sections were compacted in the laboratory in order to test the moisture sensitivity using a Hamburg Wheel Tracking Device. The binder was extracted from the field mixtures with varying amounts of RAP materials and tested to determine the effects of RAP materials on the PG grade of a virgin binder. Field cores were taken from the various mix designs to determine the percent density of each test section. A condition survey of the test sections was then performed to evaluate the short-term performance.


Asphalt, Field, Laboratory, Recycled Asphalt Pavement, Test Strip


x, 39 pages


Includes bibliographical references (pages 38-39).


Copyright 2014 Clinton Isaac Van Winkle